Range User Manual

Features
®
12-hour automatic cancel
This safety feature prevents ovenfrom continuingto operate if it has been
left on for over 12 hours. Ifa cooking function continues longer than 12 hours
withoutany optionson ovencontrol beingtouched,thisfeature turns oven
off.Any time an option is touched, 12-hourautomaticcancel is reset.
F m
code Possible Meaning
F1 Control failure
F2 Oven over temperature
F3 Sensor open or shorted
F9 Door latch circuitfailure
DOOR Door has not latched.
Oven temperature control adjustment
Yourrange is calibratedat the factoryfor propertemperature. Due to
individualvadances and preferences, it may be necessaryto adjust oven
once it has been installed.
When firstusingthe oven, followrecipe times and temperatures. Before
adjustingoven bakingtemperature, test a recipe,such as ready-to-bake
biscuits,by settingoventemperature higher or lowerthan the suggested
temperature. The bakingresultsshould help you to decide howmuch of a
temperature adjustmentis required.
An accurate digitalthermometer is necessaryto calibratethe oven. Store
purchased oventhermometers do notaccurately measure oventemperature.
Oven temperature can be increasedor decreased by 35 °F. Toavoid over
adjustingthe oven, onlyadjust the temperature by 5 °F each time.
NOTE: Remove aluminumfoil from racks and oven bottom as this will alter
oven performance. Check for blockedheat vents. If it stillappears
oven is notperformingas expected, a calibrationmay be done.
1. Turnoven temperature knob to OFF.
2. Press and hold both arrow pads for approximately5 seconds.
3. A doubledigitwill display rangingfrom -35 °F to 35 °F.
4. Immediately, presseither:
• • to increase oven temperature by 5 °F
• • to decrease oven temperature by 5 °F
• When temperature is adjusted to a cooler setting,a minussign (-) will
displaywiththe offset temperature.
5. When desiredtemperature change is displayed, release controland
change will be automaticallysaved after a few seconds. Controlwill
returnto time of day display.
• Offsettemperature change will be retainedthrougha power failure.
Service codes and tones
Electronicoven control is equippedwitha self-diagnosticsystem.
Self-diagnosticsystem alertsyou if there is an erroror problemwith the unit.
If electronicrange control soundsa sedes of short,rapidbeeps for over
16 seconds and the displayshowsan F-code, recordF-code shown.
Some F-codes can be cleared by disconnectingpowerto the range for
approximately3 minutes.If the code continues to reoccurdisconnect
electricalsupplyto range and contact an authodzedservicer.
10