Operation Manual

3
Introduction
A qualified engineer must connect refrigerator in
accordance with these installation instructions.
Measure door opening and depth and width of refrigerator.
Remove handles or doors as required. Engineer must
follow local electrical company connection regulations.
Service to or replacement of power cord must be
performed by a qualified servicer.
Recognize this symbol as a safety precaution.
Installation Requirements
1. Install on an earthed outlet with a separate 230 volt,
50 hertz., 10A circuit.
2. Protect soft flooring with cardboard or rugs.
3. Install on a floor which supports up to 363 kilograms.
4. Provide 25 millimeter clearance on top and 5 millime-
ter on sides of refrigerator.
Removing Wooden Base
CAUTION
!
To avoid personal injury or property damage, two
people must remove wooden base.
1. Tape doors on top right and left corners to prevent
doors from opening unexpectedly.
2. Slide appliance cart under side of refrigerator opposite
hinges.
3. Wrap refrigerator with blanket or pad. Thread strap
around refrigerator. Put foam shipping pads, located
in shipping carton, under strap. Tighten strap se-
curely.
4. Lower appliance cart to floor with appliance cart
handles on bottom.
5. Remove top two bolts from skid.
6. Return refrigerator and appliance cart to an upright
position. Remove strap.
7. Slide appliance cart under opposite side of refrigera-
tor.
8. Repeat steps 3-5.
9. Remove wooden base.
10. Return refrigerator and appliance cart to an upright
position and remove appliance cart.
Important
Do not leave refrigerator on its side longer than necessary
to remove bolts.
Installation Information
Removing Handles
CAUTION
!
To avoid personal injury or property damage, hold
handles securely while removing.
1. Remove door handle screw caps by lifting ends.
2. Remove door handles by removing screws.
3. Replace door handles by reversing steps 1-2.
Removing Doors
CAUTION
!
To avoid personal injury or property damage, two
people must remove and rehang doors.
1. Tape doors shut to prevent doors from opening
unexpectedly.
2. Remove top hinge cover by lifting back and
sliding forward.
3. Remove top hinge by removing screws.
4. Remove tape from freezer door.
5. Remove freezer door by lifting while opening.
6. Remove center hinge pin.
7. Remove tape from Fresh Food door.
8. Remove Fresh Food door by lifting while
opening.
9. Remove center hinge bracket by removing
screws.
10. Remove toe grille by pulling forward.
11. Remove bottom hinge cover by prying cover
away from hinge bracket.
12. Remove bottom hinge by removing screws.
13. Rehang doors by reversing steps 1-12.