Use and Care Guide

3
INSTALLATION REQUIREMENTS
Tools and Parts
Gather the required tools and parts before starting
installation. Read and follow the instructions provided
with any tools listed here.
Tools needed
■ Drill
■ 1
1
/
4
" (3 cm) drill bit
■
1
/
8
" (3 mm) drill bit for pilot holes
■ Pencil
■ Wire stripper or utility knife
■ Tape measure or ruler
■ Caulking gun and weatherproof caulking compound
■ Flat-blade screwdriver
■ Phillips screwdriver
For vented installations, you also need:
■ Saber or keyhole saw
■ Vent clamps
■ Metal snips
■ Compass or 8" (20.3 cm) circle template
Parts supplied
Remove parts from package. Check that all parts are included.
■ 2 - Metal filters
■ 6 - 4.5 x 13 mm mounting screws
■ 3 - 4 x 8 mm damper screws
■ 3
1
/
4
" x 10" (8.3 x 25.4 cm) damper/vent connector
■ 4 - 5 x 45 mm screws
IMPORTANT SAFETY INSTRUCTIONS
READ AND SAVE THESE INSTRUCTIONS