Operation Manual

PIX-3000x Operations Manual 21
Number Step Interval (Repeat Value)
This selection will make the automatic number in the previous step
increment or remain constant. If a value of "0" is entered, the number
programmed in "INITIAL NUMBER SET" will be repeatedly printed. If a
value of "1" is entered, the number programmed in "INITIAL NUMBER
SET" will increment after each print. If a value greater than “1” is entered,
the PIX-3000x will print the automatic number by the amount specified
before incrementing to the next number. For example, a value of “3”
entered will print the same number three times consecutively. The
automatic number will then be incremented by one for the next three
print outs, and so on.
1. After entering the program mode,
move the cursor under “NUMBER
SET".
2. Press ENTER to start the sequence.
3. The Number Step Interval will flash.
Press the CHANGE button until the
correct value appears in the display,
then press ENTER. This value will be
entered into memory.
4. The screen will go blank for a few
seconds after the ENTER button is
pressed and the cursor will reappear
under “ONE HOUR ADJUST”. If the
value entered in Step #3 is incorrect,
repeat Steps #1 thru #3.
5. Press the PROGRAM button to exit the
program mode.