Operation Manual

22 PIX-3000x Operations Manual
Symbol-Signal Program Mode
Accessing the Symbol-Signal Mode
To enter the Symbol-Signal Mode, perform the following:
1. Remove the cover and press the PROGRAM button to enter the
program mode.
2. Press the SYMBOL PRINT BAR on the front lower left corner to access
the Symbol-Signal Programming Mode.
3. The first area will be Symbol 1. To scroll, press the CHANGE button.
As the CHANGE button is pressed, you will scroll through the following
screens:
Definitions
The SY-1 and SY-2 program areas are standard features. The remaining
program areas are for use with the optional Master/Slave Signal PCB Kit.
If your unit is equipped with this option, please refer to the PIX-3000x
Options Manual.
SY-l
Symbol 1 program area. Press ENTER to begin creating Print
Styles using the codes from the Character Table.
SY-2
Symbol 2 program area. Press ENTER to begin creating Print
Styles using the codes from the Character Table.
SGnL
Enables you to set the day and time that the “Signal Output” or
relay contact on the Master/Slave Signal PCB will be activated.
Up to 20 days and times can be set.
d
Enables you to set the time duration (0 to 59 seconds) that the
“Signal Output” or relay contact on the Master/Slave Signal
PCB will be activated.
Snd Send Symbol 1 and 2 to another PIX-3000x.
rEc Receive Symbol 1 and 2 from another PIX-3000x.