Installation and User's Guide

Time Guardian Series – Advanced Rounding Module 14-7
All IN/OUT
If First IN/Last OUT is selected in the General tab, all punches that occur between the first IN
and OUT punches will be rounded using the Units and Point set in this tab. If First IN/Last OUT
is not selected, this rounding will be used for all punches including the first IN and last OUT
punches. A Unit and Point must be assigned to both the IN and OUT punches.
Open Schedule
Open Schedule rounding is used when a schedule for the day has no start or end time defined.
There are four types of rounding performed for the open schedule. A Unit and Point must be
entered for each type. They are:
• First IN punch of the day
• All OUT punches
• All IN punches
• Last OUT punch of the day