Installation and User's Guide

14-8 Time Guardian Series – Advanced Rounding Module
Transfer Rounding
Transfer rounding is used on punches that are designated as transfer punches by an employee
pressing the transfer button on the terminal.
Transfer rounding works the same way as Break/Meal rounding. When a punch is designated
as a transfer punch it will use transfer rounding if it is activated. If it is not activated, then
IN/OUT rounding will be used.
Hour Rounding
Hour Rounding is enabled in the General Rounding tab. You must select either Punch Pair or
Schedule as the Rounding Type. Punch Pair rounds the amount of time worked between two
punches after the automatic break/meal deductions are taken out. Schedule rounds the total
amount of time worked for a schedule after the automatic break/meal deductions are taken out.