Installation and Operation Sheet

UNPACKING AND TESTING APPLIANCE

Carefully remove the appliance from the box. Prior to installing the appliance, test to make sure the

appliance operates properly by plugging the power supply cord into a conveniently located 120 Volt

grounded outlet.

GROUNDING APPLIANCE

This appliance is for use on 120 Volts. The cord has a plug as shown in (A). An adapter as shown in (C)

is available for connecting three-blade grounding type plugs to two-slot receptacles. The green

grounding lug extending from the adapter must be connected to a permanent ground such as a

properly grounded outlet box. The adapter should not be used if a three-slot grounded receptacle is

available.

To disconnect appliance, turn controls to off, then remove plug from outlet.

LOCATING THE FIREPLACE

Plan where to locate and frame the fireplace. This will save time and money later when you install

the fireplace. Before installation consider the following:

1. Where the fireplace is located must allow for wall and ceiling clearances (see INSTALLATION)

2. Consider a location where the fireplace screen will not be exposed to direct sunlight from

windows or doors.

3. A 15 ampere, 120 Volt, 60 Hz branch circuit with proper ground must be available at the location.

Preferably a dedicated branch circuit should be provided to avoid circuit breakers to trip of fuses

to blow.