INSTALLATION AND OPERATION INSTRUCTIONS FOR TRD-26 TRD-30 TRD-33 TRD-38 TRD-44 TRD-48 SAFETY INFORMATION WARNING For your safety, always comply with all warnings and safety instructions contained in this manual to prevent personal injury or property damage. Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this appliance. INSTALLER: LEAVE OWNER’S MANUAL WITH THE APPLIANCE. CONSUMER: RETAIN OWNER’S MANUAL FOR FUTURE REFERENCE.
Please read and carefully follow all of the instruction found in this manual. Please pay special attention to the safety instructions provided in this manual. The instructions included here will assure that you have many years of dependable and enjoyable service from your Amantii product. Table of Contents IMPORTANT INSTRUCTIONS ............................................................................................................................. 3 PLUG INSTALLATION ..................................
IMPORTANT INSTRUCTIONS Please read the following instructions carefully before using the appliance. Caution - Fire, electric shock, physical injury and material damage hazards: To use the appliance, always follow the instructions for assembly, use and maintenance as well as usage cautions: 1. Carefully read and retain these instructions. 2. Before connecting the appliance, be sure that the mains voltage available matches that specified on the rating plate. 3.
the room on their own, unless constant supervision is provided. 22. If the glass is damaged, do not use the heater in order to avoid a hazard. 23. Children of less than 3 years should be kept away from unless continuously supervised. 24.
Cautions ! ! Do’s ! ! ! ! ! Always install the heater in accordance with this guide. If in doubt obtain expert advice. Always make sure the electrical socket is accessible and located adjacent to, but not above the heater. Always disconnect the heater from the electrical supply before moving it, or carrying out cleaning, maintenance. Always make sure the heater is firmly secured to prevent it from being tipped over.
PLUG INSTALLATION Your power cord will come separate from the unit, please locate it when unpacking your fireplace. The plug contained inside the box is predetermined at the factory and according to orders placed by authorized dealers. Available are UK, European, Swiss & Australian plugs. Should you require any of these options please contact your dealer for purchase. You will be required to give them the correct part number as listed below.
UNPACKING NG AND TESTING APPLIANCE Carefully remove the appliance from the box. Prior to installing the appliance, test to make sure the appliance operates properly by plugging the power supply cord into a 240 0 Volt grounded outlet. Test all aspects of its operation on (manual switches, remote and heater) to make sure all components are operating correctly. As with most electronic devices, your new electric fireplace has been designed to operate at temperatures between 5 ! (41" ") and 35 ! (95"). ).
TRD - 26 Description Voltage Watts NO HEATER MOTOR HEATER Appliance Width Appliance Height Appliance Depth Gross Weight Plug Location Cord Length Rough Wall Opening Size 220-240V 120V AC 60Hz AC 50-60Hz 1500W Max 25W 19W 27 3/8" or 69.4 cm 16 3/4" or 42.5 cm 12" or 30.6 cm 50.7 lbs or 22 kgs Left side 70 7/8” or 180 cm 26 1/4" x 17 1/4" 66.74 cm x 43.77 cm BTU 5118 1341" [335mm] 1634" [425mm] 1718" [435mm] ELECTRIC FIREPLACE 2338" [594mm] 2738" [694mm] 2541 8 12" [305.
TRD - 30 Description Voltage Watts NO HEATER MOTOR HEATER Appliance Width Appliance Height Appliance Depth Gross Weight Plug Location Cord Length Rough Wall Opening Size 220-240V AC 50-60Hz 1500W Max 25W 19W 31 1/2" or 79.9 cm 19 1/8" or 48.5 cm 12" or 30.6 cm 50.7 lbs or 22 kgs Left side 70 7/8” or 180 cm 30 3/8" x 19 5/8" 77.24 cm x 49.77 cm BTU 5118 1918" [485mm] 1912" [495mm] 1512" [395mm] ELECTRIC FIREPLACE 2721" [699mm] 3121" [799mm] 2938" [747mm] 9 12" [305.
TRD - 33 220-240V AC 50-60Hz 1500W Max 25W 19W 33 7/8" or 86 cm 21 5/8" or 55 cm 12" or 30.6 cm 50.7 lbs or 22 kgs Left side 70 7/8” or 180 cm 32 3/4" x 22 1/8" 83.24 cm x 56.27 cm BTU 5118 ELECTRIC FIREPLACE 2158" [550mm] 1834" [475mm] 2258" [575mm] Description Voltage Watts NO HEATER MOTOR HEATER Appliance Width Appliance Height Appliance Depth Gross Weight Plug Location Cord Length Rough Wall Opening Size 2978" [759.4mm] 3378" [859.4mm] 3134" [807.4mm] 10 12" [305.
TRD - 38 Description Voltage Watts NO HEATER MOTOR HEATER Appliance Width Appliance Height Appliance Depth Gross Weight Plug Location Cord Length Rough Wall Opening Size 220-240V AC 50-60Hz 1500W Max 25W 19W 39 1/4" or 99.6 cm 27 1/4" or 69.1 cm 13" or 33.1 cm 50.7 lbs or 22 kgs Left side 70 7/8” or 180 cm 38 1/8" x 27 3/4" 96.94 cm x 70.37 cm BTU 5118 2741" [691mm] 2758" [701mm] 2358" [601mm] ELECTRIC FIREPLACE 3514" [896mm] 3914" [996mm] 3718" [944mm] 11 13" [330.
TRD - 44 Description Voltage Watts NO HEATER MOTOR HEATER Appliance Width Appliance Height Appliance Depth Gross Weight Plug Location Cord Length Rough Wall Opening Size 220-240V AC 50-60Hz 1500W Max 25W 19W 45 1/4" or 115 cm 31 5/8" or 80.3 cm 14 3/8" or 36.58 cm 50.7 lbs or 22 kgs Left side 70 7/8” or 180 cm 44 1/4" x 32 1/8" 112.34 cm x 81.57 cm BTU 5118 3158" [803mm] 32" [813mm] 2818" [713mm] ELECTRIC FIREPLACE 4138" [1050mm] 451 4" [1150mm] 431 4" [1098mm] 12 1438" [365.
TRD - 48 Description Voltage Watts NO HEATER MOTOR HEATER Appliance Width Appliance Height Appliance Depth Gross Weight Plug Location Cord Length Rough Wall Opening Size 220-240V AC 50-60Hz 1500W Max 25W 19W 49 1/4" or 115.2 cm 41 5/8" or 105.7 cm 14 3/8" or 36.6 cm 50.7 lbs or 22 kgs Left side 70 7/8” or 180 cm 48 1/4" x 42 1/8" 122.54 cm x 106.97 cm BTU 5118 4158" [1057mm] 42" [1067mm] 3818" [967mm] ELECTRIC FIREPLACE 4538" [1152mm] 491 4" [1252mm] 471 4" [1200mm] 13 1438" [365.
INSTALLATION- BUILT-IN NOTE: Due to the many different materials used to build walls, it is highly recommended that you consult your local builder before you install this appliance on a wall. Preparation 1. Select a location that is not prone to moisture and is located at least 0.91m or 3 feet away from combustible materials such as curtains, drapes, furniture, furniture, bedding, paper, etc. 2. Mark the desired location on the floor and store the appliance in a safe, dry and dust free place. 3.
2. When the trim is removed, take off the front glass panel. 3. Unscrew the screws located on each side and take off the inner side steel panels.
4. Put the trim back onto the appliance and fasten with screws.(NOTE: This step is to make sure that the fireplace fits the wall opening well and there is no gap between the trim and the wall after installation) 5. Put the fireplace into the wall opening and fix it to the wall by screwing 2 screws each side.
6. Remove the trim following STEP 1. Screw back the inner side steel panels. 7. Put back the front glass panel el and screw back the trim after you finish the media decoration.
MEDIA OPTIONS Your fireplace ships with a 10 piece Birch Log Set, two (2) bags of Smoke Glass, one (1) bag of Black Vermiculite and one (1) bag of White Vermiculite. SMOKE GLASS VERMICULITE 11-PIECE BIRCH LOG SET MEDIA INSTALLATION Unscrew 4 screws and take off the trim. (NOTE: Keep hold of the front glass as it may fall down automatically when the trim is removed.) Screws locations Magnetic stones locations INSTALLING THE DECORATIVE MEDIA Pour the fire glass media into the tray.
OPERATION The fireplace can be operated either by the switches located on the left bottom of the fireplace unit or by supplied remote control. Plug the fireplace into a 15 Amp wall socket. MANUAL OPERATION 1! Press key . Press for the first time"heater work at 1500W, indicator Press for the second time, heater work at 750W"indicator lights red. lights blue. Press for the third time, the heating element turns off, indicator extinguishes.
REMOTE CONTROLOPERATION 1 2 3 1 Press the remote control’s key“ ”, its screen turns on, the flame ignites and the flame icon appears on the LCD screen of the remote control. Week, time (24h system), and temperature setting are displayed normally. Press it again, the screen of the remote control will turn off; 2 Key“ ”, flame and charcoal control switch. In case of ON, press once, the flame and the charcoal bed go out, the LCD screen does not display the LCD screen displays . .
7!Press the heating key“ .” Press for the first time ,the heating elements work at 1500W, the LCD screen displays , the indicator on the machine lights red. Press a second time , the heating elements work at 750W, the LCD screen displays , the indicator on the machine lights blue. Press a third time and the heating elements turn off, the LCD screen does not display the function icon, the indicator on the machine goes off.
for Tuesday. Press for the 7th time and it displays . Press for the 8th time and it exits and recovers to the current week day; 11!Press“ displays .” Press for the first time and the timing function turns on, the LCD screen , the machine’s indicator on the LCD screen lights green. Press again to turn off, icon goes off. After the timing function is turned on, it works according the parameter settings.
CARE AND MAINTENANCE 1. Switch off and unplug from the power supply before cleaning. 2. Using a soft, moist cloth, with or without a mild soap solution, carefully clean the exterior surface of the products. CAUTION: Allow the product to completely cool before handling or cleaning it. 3. Do not allow water or other liquids to run into the interior of the product, as this could create a fire and/or electrical hazard. 4.
REPLACEMENT PARTS This list contains replacement parts NO.
This list contains replacement parts NO.
EXPLODED VIEW 3 4 2 5 1 \ \ 9 7 6 4 12 10 11 26 8 \\
TROUBLE SHOOTING PROBLEM POSSIBLE CAUSE SOLUTION Dim or no flame Flame LED’s are burnt out. Inspect the LED’s and replace them if necessary. Change a flicker and back black cloth. Back black cloth is falling off and rolled up in the flicker. not Ember LED’s are burnt out Ember bed is glowing or dimming Appliance turns off and will not turn on Inspect the ember bed LED’s and replace them if necessary.
SERVICE HISTORY This heater must be serviced annually depending on usage.
WARRANTY FOR PRODUCTS MANUFACTURED AFTER JANUARY 1st, 2016 Amantii Imports Corp. ("Amantii " ) warrants that your newly purchased Amantii electric fireplace is free from manufacturing and material defects for a period of two (2) years from the date of the first purchase, subject to the conditions and limitations contained below.