Installation and Operation Sheet

INSTALLING WALL THERMOSTAT

WALL THERMOSTAT WIRING DIAGRAMS

NOTE: THE WALL THERMOSTAT WILL WORK ONLY WHEN THE HEATER IS SET TO TEMP. SETTING

PLEASE REFER TO THE MANUAL CONTROL AND THE REMOTE CONTROL.

Wire the wall thermostat prior to installing the fireplace.

WALL THERMOSTAT WIRING(24 VAC)

Install Wall Thermostat per instructions provided with kit and per the following information:

1. Turn off circuit breaker.

2. Remove cover plate located on the left up side of appliance.

3. Pull the wire out and cut the inside thermostat. Connect the wires to the wall thermostat as

shown below. Follow instructions provided with wall switch kit.

FLASH button: Switches mood light into flash mode, this cycles through all mood light colors.

HEATER ON/OFF button: Switching the heater ON/OFF. It has functions of setting memory.

HIGHT button: Press the high button to switch the heater to high heat setting 1500W.

LOW button: Press the low button to switch the heater to low heat setting 750W.

TEMP. button: Press the TEMP. button to switch the heater to AUTO mode. Under this mode

the heater will operate in similar way as explained above for the manual operation.