Installation and Operation Sheet

6
HARD- WIRE INSTALLATION
Turn off the appliance completely and let cool before servicing. Only a qualified service person
should service and repair this electric appliance.
If it is necessary to hard wire this appliance, a qualified electrician must remove the cord connection,
and wire the appliance directly to the house hold wiring.
This appliance must be electrically connected and grounded in accordance with local codes, if hard
wired. In the absence of local codes, use the current CSA C22.1 CANADIAN ELECTRICAL CODE in
Canada or the current ANSI/NFPA 70 NATIONAL ELECTRICAL CODE in the United States.
1. Remove the cover plate from the left side of the appliance by removing the two screws, as
shown below. Unscrew and remove power cord.
2. Attach the wiring to the junction block. Please make sure the live wire goes into the "L", the
neutral wire into "N" and the ground wire into "G".
3. Put the plate back and screw back.