Installation and Operation Sheet

9
NOTE: If operated at the Low heat setting, the fireplace will not provide as much heat output as in
the High heat setting, however the low setting will not require as much electrical power to operate.
To avoid overloading a circuit, do not plug the fireplace into a circuit that already has other
appliances working. When the fireplace is not in use switch off and unplug.
SAFETY CUT-OFF
l This appliance is fitted with a safety cut-off which will operate if the fireplace overheats (eg. Due
to blocked air vents). For safety reasons, the fireplace will NOT automatically reset.
l To reset the appliance, disconnect the appliance from the main supply for at least 10 minutes.
Reconnect the supply to the main and switch on the appliance.
REMOTE CONTROL OPERATION
For remote to function make sure the heater is plugged in and main power switch is turned to the
ON position, located on the front bottom behind the panel.
When operating the remote make sure you point the remote to the centre of the fireplace and make
sure each time you press the button, the buzzer inside the unit will beep once. It takes some time for
the receiver to respond to the transmitter. Do not PRESS the buttons more than once within two
seconds for correct operation.
DISPLAY ON/OFF button: Switching the fireplace flame and tray light ON/OFF. It has
functions of setting memory.
DISPLAY BLUE button: Adjust the blue color brightness of flame and tray.
DISPLAY YELLOW button: Adjust the yellow color brightness of flame and tray.
DISPLAY ORANGE button: Adjust the orange color brightness of flame and tray.
MOOD LIGHT ON/OFF button: Switching the mood light ON/OFF.
ADJUST button: Switching the color of the mood light.
Power on
button: The power-on button at top left corner of the remote is the main
ON/OFF power button. This will turn off all the functions and the fireplace will be in standby
mode.