Specifications

Signal generator = 300mVAC, Sine, 1kHz
Signal input = DVD1, left channel RCA input
Power state of unit: ON
Selected source on unit: DVD1
Volume on unit: MIN (lowest volume LED lit).
Bass/Treble on unit = flat (use Eq Flat button on IR remote to reset this)
Load: Connected to left channel amplifier output
Procedure
Set volume on unit to max by rotating the volume control CW until the highest LED
is lit. Adjust the frequency on the signal generator until the output is 16VAC.
(P/F) The frequency shall be between 10Hz and 30Hz.
Adjust the frequency on the signal generator up till the output is 16VAC.
(P/F) The frequency shall be >18kHz.
Values to be recorded
Value Pass Range
9a. BW Left Amp - low 10Hz – 30Hz
9b. BW Left Amp - high >18kHz
10. Bandwidth, Right Channel Power Amp
Setup
Signal generator = 300mVAC, Sine, 1kHz
Signal input = DVD1, right channel RCA input
Power state of unit: ON
Selected source on unit: DVD1
Volume on unit: MIN (lowest volume LED lit).
Bass/Treble on unit = flat (use Eq Flat button on IR remote to reset this)
Load: Connected to right channel amplifier output
Procedure
Set volume on unit to max by rotating the volume control CW until the highest LED
is lit. Adjust the frequency on the signal generator until the output is 16VAC.
(P/F) The frequency shall be between 10Hz and 30Hz.
Adjust the frequency on the signal generator up till the output is 16VAC.
(P/F) The frequency shall be >18kHz.
Values to be recorded
Value Pass Range
10a. BW Right Amp - low 10Hz – 30Hz
10b. BW Right Amp - high >18kHz
11. Noise Floor, Left Channel Power Amp
Setup
Signal generator = OFF
Signal input = DVD1, left channel RCA input
Power state of unit: ON
Selected source on unit: DVD1
Volume on unit: MIN (lowest volume LED lit).
Bass/Treble on unit = flat (use Eq Flat button on IR remote to reset this)
Load: Connected to left channel amplifier output
Procedure