Specifications

PAGE 7IN600 INSTALLATION AND OPERATION MANUAL
RS485 COMMANDS
Data: 19200, 8N1
All ASCII characters
The commands are pure ASCII. So a hex value of 0xA5 (decimal 165) is sent as ASCII ‘A’ ‘5’, or 0x41 0x35.
eg Command !04GR01??<CR> is sent as a hex string 0x21 0x30 0x34 0x47 0x52 0x30 0x31 0x3F 0x3F 0x0D
GET COMMANDS
OBJECT DATA RESPONSE DATA
!04GR01??<CR> Get source volume !04SR01XX<CR> XX-volume setting 00-FF (00 is min)
!08GR01??<CR> Get mic/line volume !08SR01XX<CR> XX-volume setting 00-FF (00 is min)
!04GL01??<CR> Get source mute state !04SL01YY<CR> YY-ON,OF,FL (On,Off, Flashing)
!08GLXX??<CR> Get mic/line enabled state XX-mic/line channel 01-04 !08SLXXYY<CR> XX-mic/line channel 01-04; YY-ON,OF,FL (On,Off, Flashing)
!10GLXX??<CR> Get source/projector state XX-source channel 01-06, 07-
off, 08-projector
!10SLXXYY<CR> XX-source channel 01-06, 07-off, 08-projector; YY-ON,OF,FL
(On,Off, Flashing)
SET COMMANDS
These commands are used to set values on the IN600. Good programming techinique should update control system visual info on the feedback responses not the ACK
message, see Feedback table.
OBJECT DATA ACK NACK
!04SR01XX<CR> Set source volume XX-volume setting 00-FF (00 is min) !04A<CR> !04N<CR>
!08SR01XX<CR> Set mic/line volume XX-volume setting 00-FF (00 is min) !08A<CR> !08N<CR>
!04SB01SH<CR> Mute source !04A<CR> !04N<CR>
!08SBXXSH<CR> Enable/Disable Mic/Line XX-mic/line channel 01-04 !08A<CR> !08N<CR>
!10SBXXSH<CR> Select source/toggle projector XX-source channel 01-06, 07-off, 08-projector !10A<CR> !10N<CR>
FEEDBACK RESPONSES
These messages are sent from the IN600 when changes occur in the IN600. This includes RS485 Set commands as well as front panel changes.
OBJECT DATA
*01SR01XX<CR> When the source volume changes XX-volume setting 00-FF (00 is min)
*02SR01XX<CR> When the mic/line volume changes XX-volume setting 00-FF (00 is min)
*01SL01YY<CR> When the source mute state changes YY-ON,OF,FL (On,Off, Flashing)
*02SLXXYY<CR> When the Mic/Line enabled stated changes XX-mic/line channel 01-04; YY-ON,OF,FL (On,Off, Flashing)
*03SLXXYY<CR> When the selected source or projector changes XX-source channel 01-06, 07-off, 08-projector; YY-ON,OF,FL (On,Off, Flashing)