Safety Instructions

ManualsBrandsAMAX INDUSTRIAL GROUP CHINA ManualsDronesVA-2080 Ultra Compact Folding Micro Drone

WARNING: Never leave product charging unattended for extended periods of

time. Always disconnect ASC-1000 from charger immediately after the

ASC-1000 is fully charged. Please refer to enclosed safety instructions.

INSTRUCTION BOOKLET

Colors and styles may vary slightly.

PACKAGE CONTAINS:

2.4G Wireless Controller Instruction BookletSpare PartsUSB Charging CordASC-1000

ASC-1000

Made in China

Conforms to safety requirements of RSS210, ASTM, CPSIA and FCC.

Ascend Aeronautics™ is the registered trademark of Amax Group USA, LLC.

Office No.3,10/F Witty Commercial Building 1A-1L Tung Choi street, Mongkok. Kowloon Hongkong

ISED NOTICE: CANADA ONLY.

This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development

Canada’s licence-exempt RSS(s). Operation is subject to the following two conditions:

1. This device may not cause interference.

2. This device must accept any interference, including interference that may cause undesired operation of the device.

L’émetteur/récepteur exempt de licence contenu dans le présent appareil est conforme aux CNR d’Innovation, Sciences et

Développement économique Canada applicables aux appareils radio exempts de licence. L’exploitation est autorisée aux deux

conditions suivantes :

1. L’appareil ne doit pas produire de brouillage;

2. L’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d’en compromettre le

fonctionnement.

CAN ICES-003(B) / NMB-003(B)

This product meets the applicable Innovation, Science and Economic Development Canada technical specifications.

Ce produit répond aux spécifications techniques pertinentes d'Innovation, Science et Développement économique applicables.

FCC Part 15 C Notice

CAUTION: Changes or modifications not expressly approved by the party responsible for compliance could void the

user’s authority to operate the equipment.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to

Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a

residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed

and used in accordance with the instructions, may cause harmful interference to radio communications. However,

there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful

interference to radio or television reception, which can be determined by turning the equipment off and on, the user

is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

• Consult the dealer or experienced radio/TV technician for help.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions :

(1) This device may not cause harmful interference, and

(2) this device must accept any interference received, including interference that may cause undesired operation.

C012-USA-V 1.0

ULTRA COMPACT FOLDING MICRO DRONE

Distributed by:

TRACTOR SUPPLY COMPANY

5401 VIRGINIA WAY

BRENTWOOD, TN 37027

For customer support,

call: 1-888-376-9601

www.TractorSupply.com

Summary of content (6 pages)

PAGE 1
ASC-1000 FCC Part 15 C Notice CAUTION: Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
PAGE 2
TABLE OF CONTENTS Features . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 Remote Control Battery Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 Charging the ASC-1000. . . . . . . . . . . . . . . . . . . . . . . . . .
PAGE 3
WARNING ASC-1000 DIAGRAM On/Off Switch DO NOT FLY YOUR ASC-1000 IN FOUL WEATHER! LED Light Charging Socket (Bottom position) Safety Guard Front Rotor Blades Rear Rotor Blades PREPARING FOR FLIGHT • Verify that there are 2 “AAA” batteries inside the remote control unit and the ASC-1000 has been fully charged. • Make sure to be in a large space with an open radius of at least 50 feet. • Make sure the empty space has no obstacles or rivers. Set your ASC-1000 on a clean flat surface before take-off.
PAGE 4
NOW YOU ARE READY TO FLY! If you have successfully synced your ASC-1000 to your controller as explained on page 4 you are now ready to fly. Before beginning to fly your drone you should familiarize yourself with how to start and stop the rotors, how to use your take off and auto land feature and how the controls work. Please carefully read and familiarize yourself with various control features explained in the next few pages.
PAGE 5
FLIGHT CONTROL Move the Throttle up to increase the speed of the motors and the ASC-1000 will rise up. CALIBRATING THE ASC-1000 Move the Throttle down to decrease the speed of the motors and the ASC-1000 will descend. If the ASC-1000 becomes unstable during the course of flying, you may need to calibrate the internal gyros. To do this place the ASC-1000 on a flat level surface. Do not start the blades. Instead move both the throttle and control stick down and to the right corner .
PAGE 6
ASC-1000 WARNING: The ASC-1000 is designed for INDOOR and OUTDOOR use. The ASC-1000 blades revolve at high speeds and can cause damage to the user, spectators and animals. Stand away from the ASC-1000 to reduce the risk of getting into the flight path. Warn spectators that you will be flying your ASC-1000 so that they are aware of its position. Before flight, inspect the rotor blades to make certain that the blades are securely fastened to the ASC-1000. WARNING! • Choking/Cutting Hazard.