Safety Instructions

ManualsBrandsAMAX INDUSTRIAL GROUP CHINA ManualsCamera & PhotoFLEX 2.0 Compact Folding Drone with HD Camera/SWITCH / Morph+ / Snap2.0

INSTRUCTION BOOKLET

WARNING: Never leave product charging unattended for extended periods of

time. Always disconnect the battery from charger immediately after the battery

is fully charged. Please refer to enclosed safety instructions.

PACKAGE CONTAINS:

Colors and styles may vary slightly.

PROPEL

ON BOARD

HD VIDEO

ON BOARD

HD CAMERA

1280 x 720 pixel

20 frames per second

Compact Folding Drone with HD Camera

FLEX 2.0

Instruction

Manual

Spare Parts Battery

FLEX 2.0™

USB Charger 2.4G Wireless

Controller

Phone Holder

CHOKING HAZARD

Small parts.

Not suitable for children under 3 years.

WARNING!

FCC Part 15 C Notice

CAUTION: Changes or modifications not expressly approved by the party responsible for compliance could

void the user’s authority to operate the equipment.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device,

pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against

harmful interference in a residential installation. This equipment generates, uses and can radiate radio

frequency energy and, if not installed and used in accordance with the instructions, may cause harmful

interference to radio communications. However, there is no guarantee that interference will not occur in a

particular installation. If this equipment does cause harmful interference to radio or television reception,

which can be determined by turning the equipment off and on, the user is encouraged to try to correct the

interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

• Consult the dealer or experienced radio/TV technician for help.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions :

(1) This device may not cause harmful interference, and

(2) this device must accept any interference received, including interference that may cause undesired

operation.

This equipment complies with FCC/ IC radiation exposure limits set forth for an uncontrolled environment.

This equipment should be installed and operated with minimum distance 20cm between the radiator and

your body.

Cet équipement est conforme aux limites d'exposition aux radiations FCC/IC établies pour un

environnement non contrôlé. Cet équipement doit être installé et utilisé avec une distance minimale de 20

cm entre le radiateur et votre corps.

CAN ICES-3(B)/NMB-3(B)

This product meets the applicable Innovation, Science and Economic Development Canada

technical specifications.

This product is manufactured by Amax Group

12645 Memorial Drive Suite F1 #388 Houston, TX 77024

Propel™ and Propel RC™ are the licensed trademarks of Rooftop Group LTD Singapore.

INDUSTRY CANADA NOTICE: CANADA ONLY.

This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development

Canada’s licence-exempt RSS(s). Operation is subject to the following two conditions:

1. This device may not cause interference.

2. This device must accept any interference, including interference that may cause undesired operation of the device.

L’émetteur/récepteur exempt de licence contenu dans le présent appareil est conforme aux CNR d’Innovation, Sciences et

Développement économique Canada applicables aux appareils radio exempts de licence. L’exploitation est autorisée aux deux conditions

suivantes :

1. L’appareil ne doit pas produire de brouillage;

2. L’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d’en compromettre le

fonctionnement.

Conforms to safety requirements of

FCC, RSS247, RSS210.

Costco Wholesale Canada Ltd.*

415 W. Hunt Club Road

Ottawa, Ontario

K2E 1C5, Canada

1-800-463-3783

www.costco.ca

* faisant affaire au Québec sous

le nom les Entrepôts Costco

Made in China

CT-6168

C004-CA-V1.0

Summary of content (8 pages)

PAGE 1
FCC Part 15 C Notice FLEX 2.0 CAUTION: Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
PAGE 2
TABLE OF CONTENTS Features . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 Remote Control Battery Installation. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 Charging the FLEX 2.0™ Li-Poly Battery . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 Install The Aircraft Battery. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
PAGE 3
FLEX 2.0™ DIAGRAM WARNING DO NOT FLY YOUR FLEX 2.0™ IN FOUL WEATHER! Camera Propeller B Propeller A FLIGHT PREPARATION Propeller B • Verify that there are 4 “AAA” batteries inside the remote control unit and the FLEX 2.0™ battery has been fully charged. • Make sure to be in a large open space preferably a field or a park with an open radius of at least 60.96 m (200 ft). • Make sure to start your drone on a clean flat level surface before take-off.
PAGE 4
NOW YOU ARE READY TO FLY! If you have successfully synced your FLEX 2.0™ to your controller as explained on page 4 you are now ready to fly. Before beginning to fly your drone you should familiarize yourself with how to start and stop the rotors, how to use your auto land feature and how the controls work so please carefully read and familiarize yourself with various control features explained in the next few pages.
PAGE 5
ADJUSTING THE TRIM NOTE: The FLEX 2.0™ is already properly trimmed and calibrated right out of the box and should not require any trim adjustments before flying. Some more experienced pilots may want to adjust trim settings for their style of flying. After several crashes you may need to adjust trim settings for the FLEX 2.0™ to be more balanced. Forward/Backward Trim • If your FLEX 2.
PAGE 6
LIVE VIDEO STREAMING SETUP Your FLEX 2.0™ comes equipped with an onboard digital camera that takes both video and still photographs to your mobile devices. WHAT YOU WILL NEED TO GET STARTED USING YOUR CAMERA 1. One Apple or Andriod phone* (not included) 2.
PAGE 7
HELP PAGE 3 CAMERA SETTINGS 4. If you’re still encountering difficulties please contact our customer service department at www.amaxbrands.com REPLACING THE PROPELLER BLADES Your FLEX 2.0™’s propeller system is a precision instrument that may need repair or replacement from time to time for optimal flight function. Crash landing at high-speed may cause damage to your FLEX 2.0™’s propellers. 1. The FLEX 2.
PAGE 8
FLEX 2.0™ WARNING: The FLEX 2.0™ is designed for OUTDOOR use. The FLEX 2.0™’s blades revolve at high speeds and can cause damage to the user, spectators and animals. Stand away from the FLEX 2.0™ to reduce the risk of getting into the flight path. Warn spectators that you will be flying your FLEX 2.0™ so that they are aware of its position. Before flight, inspect the rotor blades to make certain that the blades are securely fastened to the FLEX 2.0™ . WARNING! • Choking/Cutting Hazard.