Safety Instructions
X20
WARNING
:
The X20 is designed for INDOOR and OUTDOOR use. The X20 blades revolve at high speeds and can cause damage to
the user, spectators and animals. Stand away from the X20 to reduce the risk of getting into the flight path. Warn spectators
that you will be flying your X20 so that they are aware of its position. Before flight, inspect the rotor blades to make certain
that the blades are securely fastened to the X20.
WARNING!
• Choking/Cutting Hazard. Small Parts/Sharp Rotor Blades.
• Keep hands, hair and loose clothing away from the propeller when the power switch is turned to the ON position.
• Turn off the transmitter and X20 power switches when not in use.
• The included charger is built specifically for the X20 Li-Poly battery. Do not use it to charge any other battery.
• New alkaline batteries are recommended for maximum performance.
• Parental supervision recommended when flying X20.
BATTERY WARNINGS
RECHARGEABLE BATTERY:
This X20 uses a Li-Poly rechargeable battery. If battery no longer stays charged, dispose of battery properly according to
local disposal requirements.
CONTROLLER BATTERIES:
Remote control requires 2 “AAA” batteries (not included). Please read the important battery safety warning below.
• Do not mix alkaline, standard (carbon-zinc) and rechargeable batteries (nickel metal hydride).
• Do not mix old and new batteries.
• Non-rechargeable batteries are not to be recharged.
• Rechargeable batteries are to be removed from the item before being charged (if removable).
• Rechargeable batteries are only to be charged under adult supervision.
• Exhausted batteries should be removed immediately and must be recycled or disposed of properly
according to state or local government ordinances and regulations.
• The supply terminals are not to be short-circuited.
• Only batteries of the same or equivalent type as recommended are to be used.
• Batteries are to be inserted with the correct polarity (see inside booklet for diagram).
• Do not dispose of batteries in a fire - batteries may leak or explode.
CARE AND MAINTENANCE
• Always remove the batteries from the wireless infrared remote control when it is not being used for an extended period
of time.
• To clean, gently wipe the remote control and X20 with a clean damp cloth.
• Keep the toy away from direct heat or sunlight.
• Do not submerge the toy into water. This can damage the unit beyond repair.
• Parental guidance recommended when installing or replacing the batteries.
HOW TO DO 360º STUNT ROLLS
1. In order to make your X20 do 360º rolls you must fully charge your battery.
Note: The X20 will not do 360º stunt rolls in Mode 1 or under low battery indication (The LED
lights on the drone will be flashing).
2. Once you are ready to attempt a 360º roll, simply depress and let go of the "STUNT" button on the top
right hand side of your controller (see Remote Diagram on page 3). You will hear beeping sounds, this
means you are now in “STUNT MODE."
3. Now quickly move your right control stick in any of 4 directions; up, down, left or right. Your X20
copter will instantly roll in the associated direction. See diagram below.
Note:
After performed the stunt roll, the beeping sounds will stop. Repeat step 2 to 3 if you wish to do it
again.
If the X20 becomes unstable during the course
of flying, you may need to calibrate the internal
gyros. To do this place the X20 on a flat level
surface. The LEDs on the X20 will flash quickly
and then remain solid, this indicates your drone
has been recalibrated (see diagram E).
H
Rear
REPLACING THE PROPELLER BLADE
Your X20 propeller system is a precision instrument that may need repair or replacement from time to time for optimal
flight function. Crash landing from high-speed aerial flights may cause damage to your X20’s propellers.
1. X20 have four blades, two gray propellers on the front, and two black propellers on the back.Please note that the
blades and the X20 are labeled with an embossed A or B (see the diagram H).
2. When replacing the propeller blades, gently remove the blade
from the rotor shaft. Make sure to match both the color of the
blade and the indication letter on the blade with the letter on
the aircraft.
3. Replace the broken blade with the correct spare blade.
9
10
Front
F
360˚Stunt Roll
G
CALIBRATING THE X20
Blade Front Left = A
Blade Front Right = B
Blade Rear Left = B
Blade Rear Right = A
E