Working Diagram (How It Works) 1 2 3 4 Package Contents 1).outdoor antenna 2).60 ft RG6 cable 3).booster& indoor antenna 4). Power supply Connect the System 1.Outdoor Antenna Installation: Must over the roof line.
.Connect the outside antenna to the 30 feet RG6 cable, seal and fix the connector Secure the cable near the antenna to prevent cable damage caused by wind shaking 3.Connect the outside antenna to the “OUTSIDE” port of booster. 4.Connect the inside antenna to the “INSIDE” port on the booster. 5.Plug in the power adaptor and connect it to the nearest power outlet (surge protector recommended). The LED light will be illuminated after the power is turned on.
Caution Seperation between Outside and Inside Antenna To Avoid Osillation Minimum Required Separation Distance Between every Indoor and Outdoor Antenna： 20 ft (6 meters) horizontal distance 13 ft (4 meters) vertical distance(As far as possible) Note that the indoor antenna and the outdoor antenna cannot face each other. Seal the Joints of the Outdoor Antenna and Cable 1.Make sure connectors are well screwed in 2.
Caution Properly Handle Excess Cables If the coiled cable is too close to the antenna or booster, the system will be unstable. Make sure these coiled cables are more than 6 feet(2 meters) from the antenna or booster WARRANTY The Outdoor Unit and Indoor Unit are covered under a three-year product warranty for failures or defects that result from craftsmanship and/or materials. Dated proof of purchase should be retained for use in warranty cases.
