IMPORTANT SAFEGUARDS Read these instructions carefully and retain them for future usa. If this product is passed to a third party, then these instructions must be included. When using electrical appliances, basic safety precautions should always be followed to reduce the risk of fire, electric shock, and/or injury to persons including the following: + Read all instructions before using this product. * Keep this instruction manual for future use.
not use it in areas where gasoline, paint, or flammable liquids are used or stored. * Use this heater only as described in this manual. Any other use not recommended by the manufacturer may cause fire, electric shock, or injury to persons. + A heater has hot and arcing or sparking parts inside. Do A * Always plug heaters directly Into a wall outlet/receptacle. Never use with an extension cord of relocatable power tap {outlet/power strip).
= Disconnect the power plug from the electrical outlet when not in use and before cleaning. + Always turn the appliance off before disconnecting the power plug. + The heater must not be located immediately below a socket-outlet. FYE This heater is not equipped with a device to control the room temperature. Do not use this heater in small rooms when they are occupied by persons not capable of leaving the room on their own, unless constant supervision is provided.
Intended Use = The heater is intended for temporarily heating residential rooms. « The heater is intended solely for indoor non-commercial use. + Use the product only as described in this manual. + No liability will be accepted for damage resitting from improper use or non-compliance with this manual. Before First Use * Carefully remove all packaging materials and retain for future use. * Check for transport damages. * Place the product on a stable, flat and heat-resistant surface.
Mode Setting 1. To start heater operation, turn the Thermostat control clockwise to the highest setting. 2. Switch the Selector to your desired heat settings: Fan Only Fan) Low Heat (LO) High Heat (H) 3. The power light will remain lit during operation. Thermostat Control 1. Turn the thermostat control clockwise to the highest position to start heater. Allow heater to operate and warm up the room. 2.
= Dry the product after cleaning. * Never use corrosive detergents, wire brushes, abrasive scourers, metal or sharp utensils to clean the product. Storage and Maintenance = When not in uss, store the product in its original packaging. * Do not wrap the cord around the product. «Store the product In a cool, dry place. Troubleshooting Bra blat Milan =(0) If the heater does ~~ * Check If the power plug Is connected to o5 not operate: the power outlet.
Feedback and Help Love it? Hate it? Let us know with a customer review. Amazon Basics is committed to delivering customer-driven products that live up to your high standards. We encourage you to write a review sharing your experiences with the product.
