Installation Guide

SOLO COLLECTION
INSTALLATION INSTRUCTIONS
Please read the following information before installing and using your Heated Towel Rack.
WARNINGS
- The unit requires a 120 volt, 60Hz power source and should be plugged into a GFCI protected circuit.
- Plug-in units should be connected to a grounded outlet with a minimum rating of 10 amps.
- Unit is designed for drying towels. Under no circumstances should anybody climb on or hang on unit.
- Unit is intended for indoor use only. Do not place units inside a shower, sauna, steam room, or wherever unit would be exposed to water.
CAUTION
- As this is a heating device, the surface temperature can increase depending on the ambient temperature in the room and the number of towels applied to the unit.
- Suitable for 1-2 towels — do NOT overload.
- Overloading the unit will cause the unit to become extremely hot and may result in a burn if touched and/or damage to towels.
OPERATING INSTRUCTION
- After legs are installed. Plug-in to appropriate outlet.
- Remove the protective cover from the switch and turn it to the on position.
- The indicator light will glow red and the towel warmer will start to heat — Allow 10-20 minutes to heat up.
- This towel warmer has been designed to run continuously — Turn off the switch or unplug the cord when the towel warmer is not in use for long periods of time.
- Never use an extension cord for Plug-in models.
- The Solo Collection features an
Integrated on/off switch.
- Remove plastic cover after installation.
- Switch is located on the top of the
right vertical bar.
- Press switch to power on unit.
- Switch will illuminate when on.
CARE & MAINTENANCE
- Towels which contain soap or detergent residue may appear to have scorch marks; this is simply discoloration of the residue in the towels themselves.
- The unit is constructed from extremely durable 304 stainless steel. To maintain a good appearance, follow these simple instructions:
- For routine cleaning, simply switch off the unit, allow to cool to room temperature, wipe with a damp cloth and buff with a soft, dry cloth.
- Under no circumstances should abrasive cleaners be used to clean the unit.
CONTACT
TEL:
404‐3509738
FAX:
404‐3550166
EMAIL:
[e-mail]
WEB:
www.ambaproducts.com
INCLUDED COMPONENTS
INSTALLATION INTEGRATED SWITCH
AVAILABLE MODELS
SAFSP-24
SAFSB-24
SAFSP-33
SAFSB-33
24 - 24” Wide Model
33 - 33” Wide Model
SWITCH
REMOVE
SWITCH COVER
BEFORE USE
P-Polished B-Brushed
! CAUTION — SURFACE OF UNIT IS HOT WHEN ON !
TOOLS REQUIRED
ELECTRICAL INFO
Two year limited warranty
with proof of purchase will
apply if all Terms and
Conditions of Sale are met
and Installation Instructions
are adhered to.
WARRANTY
www.ambaproducts.com/warranty
FOR FULL WARRANTY VISIT:
150
watts
1.35
amps
120
volts
1x
DB
2x
A
2x
C
2x
A.
B.
D.
C.
HEATED TOWEL RACKS
SAFS-24 | SAFS-33