Installation Sheet

ManualsBrandsAmba ManualsShop All AmbaAmba Elory 20-1/2" W x 30-3/8" H 115 V Hardwired Stainless Steel Towel Warmer

Instructions for Use & Installation

ELORY COLLECTION

CONSULT THIS INSTRUCTION MANUAL IN ITS ENTIRETY PRIOR TO

THE HANDLING & INSTALLATION OF ANY TOWEL WARMER

FOLLOW THE GENERAL GUIDELINES & INCLUDED WIRING DIAGRAM.

790 Pickens Industrial Dr,

Marietta, GA 30339 USA

Phone : (404) 350 9738

Fax : (404) 355 0166

www.ambaproducts.com

3165407

IP 54

SKU Width HEIGHT Power Amps BTU

E2830

28 3/8” 30 3 /8” 270 watts 2.3 921

E2130 20 1/2” 30 1/2” 180 watts 1.6 614

110v

COMPONENTS

5 3

1 – Plastic Anchor

2 – Washer

3 – Threaded wall support

4 – Fixing Screw

5 — Threaded Fastener

1 – Locking Nut

2 – Cover Plate

3 – Connector

4 – Cover Plate Screws

5 — Threaded Fastener

Summary of content (5 pages)

PAGE 1
IP 54 Instructions for Use & Installation 3165407 ELORY COLLECTION 110v SKU Width HEIGHT Power Amps BTU E2830 28 3/8” 30 3/8” 270 watts 2.3 921 E2130 20 1/2” 30 1/2” 180 watts 1.
PAGE 2
IMPORTANT INSTRUCTIONS WARNINGS & PRECAUTIONS BEFORE INSTALLING THE TOWEL WARMER CAREFULLY READ ALL INSTRUCTIONS Ensure that VOLTAGE (V) & FREQUENCY (HZ) indicated in the serial number plate correspond to the voltage & frequency available in the place of installation At receipt of goods, ensure that packaging is intact: ANY DAMAGES THAT OCCUR DURING TRANSPORT ARE NOT COVERED BY WARRANTY • • • • • • This heater is hot when in use — to avoid burns do not let bare skin touch hot surfaces For indoor use onl
PAGE 3
MAINTENANCE UPKEEP & CARE • • • • • Before any maintenance operation ensure that the power source is disconnected and that the switch is in the off position Before any maintenance wait for the unit to cool down completely Clean the outside surface with a soft cloth and liquid detergent or stainless steel cleaner Do not use abrasive cleaning or scouring products To maintain the delicate external finishes use the following methods with each finish: • • • • • Brushed finishes: rub the soft cloth following t
PAGE 4
INSTALLATION CAUTION: INSTRUCTIONS DO NOT TAKE OFF THE PROTECTIVE P.V.C. TAPE BEFORE INSTALLING TOWEL WARMER TO AVOID SCRATCHING, MARKING OR GRAZING THE SURFACE.
PAGE 5
Built-in DIGITAL HEAT CONTROLLER OPERATIONAL INSTRUCTIONS STEP 1 INCREASE POWER LEVEL POWER LEVEL DISPLAY DECREASE POWER LEVEL On-OFF TOGGLE TOUCH CONTROLS WORK BY A LIGHT TOUCH OF YOUR FINGER TIP After switching on unit wait a few seconds for the self Calibration (lights up in circular movement); Choose from 9 different heat levels. Controller can handle up to a maximum power load of 1200watts.