Jeeves Installation Guide

ManualsBrandsAmba ManualsTowel WarmersECW

1 of 3

JEEVES INSTALLATION INSTRUCTIONS

* Please read the Safety Measures before installing your Jeeves Heated Towel Rail.

* All installations should be in accordance with National and Local electrical codes.

* The Heated Towel Rail should be installed by a certified electrician.

* To ensure the Heated Towel Rail is mounted securely, fasteners should be secured in

studs, or alternatively, in structural members that are placed behind the rails.

Step 1

Attach the 4 stainless steel tube assemblies (a) onto the unit as

shown in Fig 1. Allow the set screw to face downwards.

Install and secure one slotted bolt (b) through the center of the

white bushing, threading it onto the nut welded on the unit.

Step 2

Decide where to install unit and the location of the single gang

junction box. This can be done by either placing the assembled

rail against the wall or taking approximate dimensions from the

drawing supplied.

Remember: Unit should not be mounted closer than 2 inches below an overhanging surface

(i.e. shelf) and no closer than 1-1/4 inches above the floor and/or baseboard.

Step 3

Install single gang junction box in the desired

position. Secure supplied cover plate onto box.

Place unit against wall with wire cover tube inserted

in cover plate. To achieve this, the cord needs to be

fed through the slot at the end of the tube. Make

sure that the unit is mounted squarely. Use a pencil

to lightly mark the position of all four tubes. Fig 2.

Step 4

Remove unit and center

the marking disk in the

circles marked on the wall

in Step 3.

Place the tapered bushing

circles marked in Fig 3.

and insert supplied screw

through center of the

tapered bushing and fasten

to wall as in Fig 4.

If rail is installed on a tiled

surface use a toggle bolt

anchor.

(

)

(a)

(

)

Summary of content (3 pages)

PAGE 1
JEEVES INSTALLATION INSTRUCTIONS * * * * Please read the Safety Measures before installing your Jeeves Heated Towel Rail. All installations should be in accordance with National and Local electrical codes. The Heated Towel Rail should be installed by a certified electrician. To ensure the Heated Towel Rail is mounted securely, fasteners should be secured in studs, or alternatively, in structural members that are placed behind the rails.
PAGE 2
Step 5 Remove the cover plate and slide it to the back of the wire cover tube. Now place the unit over the tapered bushings installed in Step 4. Securely hand-tighten each of the four set screws on the bottom of the tubes. Remove wire from slot in the end of the horizontal tube. Position the wire from the rail and the wire from the junction box to allow for connection. (Fig 5) Splice the wires using the connectors provided and place them inside the junction box.
PAGE 3
Safety Measures 1. Types of Safety Measures 1.1 Warning: States a hazard which may pose serious injury or death if exact installation instructions are not followed. 1.2 Caution: States a hazard which may pose minor injury and/or product damage if installation instructions are not followed. 1.3 Note: Helpful information which will facilitate installation. 2. Warnings: 2.1. These units should be installed by a certified electrician. 2.2.