Quadro Instructions for Use and Installation

4
www.ambaproducts.com
INSTALLATION
INSTRUCTIONS
CAUTION:
DO NOT TAKE OFF THE PROTECTIVE P.V.C. TAPE BEFORE INSTALLING TOWEL WARMER TO
AVOID SCRATCHING, MARKING OR GRAZING THE SURFACE.
Setscrew
Threaded
Long Tube
• Take the threaded long tube ( point 3) and screw
it down completely to the threaded wall-support
(point 2) ; to adjust the distance from wall
unscrew tube(point 3)
Brick Wall
Plastic
Anchor
Brick wall:
• Drill the holes in the wall ø6 mm ( 1/4 inches)
and put the plastic anchor (1) into the wall;
Drywall:
• Leave out the plastic anchor (1) and proceed
with step 2
STEP 1
STEP 3
STEP 5 STEP 6
STEP 2
Drywall
Anchor
Screw
Drywall:
• Fasteners should be fixed to studs or structural
members behind the drywall
• If not possible on both sides, toggle bolts can
be used on one side.
• Proceed laying the threaded wall-support
(point 2) on the hole and fasten it with the
anchor bolt screw: repeat this procedure also
for the other points marked on the wall
Fixing Screw
Bushing
BACK SIDE OF
TOWEL WARMER
• Laythe bushing (point 6) on the holes of the towel
warmer. And fasten it with the fixing screw (point 5);
• Repeat this procedure also for the other connecting
holes of the towel warmer.
• Install the towel warmer in the four connections as
shown in drawing. Technical Drawings can be found
on our website www.Ambaproducts.com
• For each leg fasten the Setscrew and place the
cover onto the bracket
Threaded Wall-
Support
STEP 4
INSTALL DIGITAL HEAT CONTROLLER OR
SWITCH — SEE PAGES 7 OR 8.
REMOVE THE PROTECTIVE P.V.C. TAPE BEFORE
SWITCHING THE TOWEL WARMER ON