Installation Sheet

Page 2

BEFORE STARTING ASSEMBLY MAKE SURE ALL COMPONENTS LISTED ARE IN THE PACKAGE

DO NOT OVER-TIGHTEN SET SCREW TURN UNIT ON WITH SWITCH

1 2

22 7/16”

570mm

18 7/8”

480mm

CENTER OF

WALL PLATE

3 1/8"

80 mm

SWITCH

RADIANT SQUARE

INSTALLATION INSTRUCTIONS

! CAUTION — SURFACE OF UNIT IS HOT WHEN ON !

PAGE 1
RADIANT SQUARE INSTALLATION INSTRUCTIONS BEFORE STARTING ASSEMBLY MAKE SURE ALL COMPONENTS LISTED ARE IN THE PACK AGE 1 2 A 22 7/16” 570mm E B C 18 7/8” 480mm D 3 1/8" 80 mm I G CENTER OF WALL PLATE 3 H 4 F SWITCH DO NOT OVER-TIGHTEN SET SCREW TURN UNIT ON WITH SWITCH ! CAUTION — SURFACE OF UNIT IS HOT WHEN ON ! Page 2
PAGE 2
RADIANT SQUARE INSTALLATION INSTRUCTIONS WARNINGS - Please read the following information before installing and using your Heated Towel Rack. These units should be installed by a certified electrician in accordance with the National Electrical Code (NEC) and the Canadian Electrical Code (CEC). The unit requires a 120 volt, 60Hz power source and should be installed on a GFCI protected circuit. Plug-in units should be connected to a grounded outlet with a minimum rating of 10 amps.