Sirio Instructions for Use and Installation

5
www.ambaproducts.com
IMPORTANT INSTRUCTIONS
WARNINGS & PRECAUTIONS
DIGITAL HEAT CONTROLLER
All EMMESTEEL electric models can be integrated with the Digital heat Controller
Manages the power supply to offer 9 different heat levels at a maximum power load of 1200w
The DHC control system is certified and ratified according to American and European norms for electric devices,
made of components that meets the requirements of current safety regulations. The Digital Heat Controller is
certified “ETL Canada, USA” and “CE with protection degree IP54”, that ensure consumer safety.
WORKS BOTH WITH 115V AND 220V POWER SUPPLY SYSTEMS
USE ONLY ON 15AMPERE BRANCH CIRCUIT
• Always ensure that at receipt of goods, the packaging is intact apon reciept
• Damage occurring during transportation are not covered by the warranty
• Be careful while handling the Digital Heat Controller in order not to scratch, mark, graze or dent the surface: the
warranty does not cover these damages
• Do not use the digital heat controller in case of wire or damaged plug, in event of malfunction, fall or other kind of
circumstances: contact Amba Products- see the “general terms of sale”
• We recommend that p.V.C. Protective tape is left in place until the digital heat controller is fully installed; however
please remove tape before switching unit on as p.V.C. Protective tape may leave glue residues
• The digital heat controller regulates the power putput of emmesteel range of towel warmers and heaters indicated in
the catalogue and it is made for indoor use only
• Ensure that room trip switch is off before any operation;
• Wrong wiring connection to the power source will cause sparks and the burning/damage to the digital heat controller·
carefully consult the wiring diagram
• Do not insert foreign bodies inside the digital heat controller in order to avoid electric shocks or damages to it
• Do not use the digital heat controller close to combustibles, paints or any other inflammable liquid
• Keep the digital heat controller reasonably away from water (as required by your local electrical codes), in order to
avoid electric shocks, or damages to the digital heat controller
• Before installation and wiring consult the serial number label on the digital heat controller or read the electric
specification table inside the manual of instructions
• Ensure that the power source switch is in off position
• While working, the digital heat controller may heat up-refer to data indicated in the serial number label
• The digital heat controller has been created for hardwired installation only
• During the installation ensure that the gasket is in the original and appropriate location, for water protection
• Utilize the digital heat controller not as described in this manual may cause fire, electric shocks or injuries
Maintenance
• Before performing maintenance ensure that the power source switch is in off position
• Clean the outside surface with a soft cloth and liquid detergent, similar to glass cleaning
• Do not use abrasive or scouring products
• To mantain the delicate external finishes, rub with a soft cloth following the grain of the brushed finish; for polished
finishes do not clean by moving cloth in a circular motion
• For any questions or concerns contact Amba Products