User's Manual

AMB2561_MA_V1_0 Page 6 of 11 Date: 03/2014
5. Push “reset” button.
6. Now the module settings may be read and edited.
4 Disconnecting the DTR-Signal
If the reset functionality via the virtual COM port is not required or it causes problems with
certain applications, then this connection can quite easily be removed.
For this the housing of the USB-stick has to be opened first. Now the DTR signal can be
removed by desoldering one resistor (see picture below: package 0402). The reset button on
the stick is not affected by this procedure. Finally the housing may be closed again.