User's Manual
Table Of Contents
- 1 Preface
- 2 Introduction
- 3 Product Overview
- 4 Ambient Network
- 5 Installation
- 6 Configuration
- 7 Deployment
- 8 Example Deployments
- 9 Firmware Upgrades
- 10 Troubleshooting
- 11 Appendices
User Manual
3000 SERIES 3
rd
GENERATION ACTIVE RFID
6.5.4 Enable localization of SmartPoints
In order to enable SmartPoints to locate themselves, you have to activate their location engine driver.
The 'Drivers' tab of Ambient Studio can be used to do that. Perform the following steps to configure
the localization engine:
1. In the left network tree control select a SmartPoint.
2. In the second DDI tree control navigate to driver class '13:Localization' and expand the field.
3. Navigate to driver '2:Engine'.
4. Press the 'Configure Driver' button to the upper right. A dialogue will open. See Illustration
20
5. Fill in the appropriate driver parameters (see explanation below).
6. Set the configuration of the engine by pressing the 'Set Full Configuration of Driver'
7. button to the left side of the dialogue. Wait for the request to complete: the icon to the lower
left should indicate a green 'OK' icon.
35/73 Ambient Systems B.V.
Illustration 19: Map tab of Ambient Studio with example floor plan and infrastructure devices