User Manual

Model: MR3000
Revision P1A/18042014
USER MANUAL
MicroRouter MR3000 v2.0
Ambient Systems B.V.
Page 8 of 14
Demmersweg 66 • 7559 BN Hengelo • The Netherlands
T: [phone] • F: [phone] • www.ambient-systems.net
KvK: 08122911 • VAT NL: 81297625381
CHECK.TRACK.TRACE.
5 LED Behavior
5.1 Position of the LEDs
The MicroRouter is equipped with two LEDs, one provides an indication of the power source and one provides
feedback on the network status. Please note that in the picture below the antenna is oriented to the upper
side.
A solid color in the LED figures indicates that the LED burns constantly in the particular color. A dotted color
means that the LED blinks in the indicated color.
5.2 Boot
When the MicroRouter is powered on, the device will initiate a short boot sequence of a few seconds. During
this period the RED network status LED will burn for a short period.
5.3 LED indications of network status
After the boot sequence is completed, the MicroRouter will commence normal operation. The figure below
indicates how the MicroRouter will display the three network states: (1) Discovering a network or registering
with a network, (2) normal operation mode, the MicroRouter acts as node in the mesh network (i.e.
registration successful) and (3) the connection is lost or registration unsuccessful, it waits a certain amount of
time before trying to discover and register again.
Mains powered
Battery powered
Discovering or
registering with a
network
Registered with a
network. This is the
desired state of the
device
Power LED
Network LED