User Manual

Model: MR3000
Revision P1A/18042014
USER MANUAL
MicroRouter MR3000 v2.0
Ambient Systems B.V.
Page 9 of 14
Demmersweg 66 • 7559 BN Hengelo • The Netherlands
T: [phone] • F: [phone] • www.ambient-systems.net
KvK: 08122911 • VAT NL: 81297625381
CHECK.TRACK.TRACE.
Lost connectivity. The
device waits in this state
before trying again to
discover and register
5.4 LED indications of power status
When the device operates on battery, the network status LED will blink, as explained in the previous section,
while the power status LED is off. The figure below indicates the various states:
Fully charged
Battery is charging
Battery charging is (temporarily)
suspended
Operating on battery
5.5 LED indications invoked by the System::Led driver (0:5)
In some cases, MicroRouters can be installed out of range e.g. on the ceiling of a warehouse. In order to
facilitate easy recognition of a particular MicroRouter devices, a uniquely LED flashing pattern is implemented,
which can be triggered using the System::Led driver (0:5).
2 minutes
Use Ambient Studio to request/invoke the DDI function (0:5:1) and locate the device with alternately blinking
RED power and network status LEDs. After roughly 2 minutes, the LED indication will display the current
device status again.