User's Manual

User Manual
3000 SERIES 3
rd
GENERATION ACTIVE RFID
T e c h n i c a l S p e c i f i c a t i o n s
F r e q u e n c y R a n g e * 2.42 to 2.455 GHz, IEEE 802.15.4 PHY compliant
T X ( M a x i m u m r a d i a t e d
p o w e r ( E I R P ) )
TBD
R X s e n s i t i v i t y -103.6 dBm @ 1%PER
T y p i c a l R a n g e i n d o o r TBD
T y p i c a l R a n g e o u t d o o r TBD
T y p i c a l B a c k u p B a t t e r y
L i f e
5 days
1
P h y s i c a l S p e c i f i c a t i o n s
M o u n t i n g
Enclosure with 4 screw mounting holes
D i m e n s i o n s ( H x W x D )
D i m e n s i o n s w i t h o u t
f l a n g e s / g l a n d ( H x W x D )
50 x 97 x 131 mm (excluding antenna)
50 x 68 x 100 mm (excluding antenna)
W e i g h t
232 gr (excluding adapter)
C o l o u r
Gray
P o w e r S o u r c e
External, 6.0 – 12.6 V, 500 mA
B a c k u p B a t t e r y
3 x rechargeable AA Nickel Metal Hybrid
A n t e n n a
External omni-directional swivel antenna (RP-SMA connector), see 3.3.3
O p e r a t i n g T e m p e r a t u r e
-40˚C to +85˚C
S t o r a g e T e m p e r a t u r e
-40˚C to +85˚C
I n g r e s s P r o t e c t i o n
IP65
R o H S
yes
*the radio frequency range is restricted to the above in accordance with FCC certification
3.3.3 Important note, GW3000 and MR3000 antennas
The GW3000 and MR3000 devices have been designed to operate with the antennas listed below,
and having a maximum gain of 5 dBi. Antennas not included in this list or having a gain greater than
5 dBi are strictly prohibited for use with this device. The required antenna impedance is 50 ohms.
● 2.2dBi gain, swivel antenna – TLB-2400-900LD-2.2A
● 5dBi gain, swivel antenna – TLB-2400-900LD-5A
To reduce potential radio interference to other users, the antenna type and its gain should be so
chosen that the equivalent isotropically radiated power (e.i.r.p.) is not more than that permitted for
successful communication.
WARNING: Any modifications to the units, unless expressly approved by the party responsible for
compliance, could void the user's authority to operate the equipment.
In order to comply with the RF Exposure requirements of Industry Canada and the FCC, a minimum
of 20cm separation distance must be maintained between the antenna of this device and all persons.
1 Typical reporting intervals, always in network, backup batteries fully charged
13/73 Ambient Systems B.V.