User's Manual
Table Of Contents
- 1 Preface
- 2 Introduction
- 3 Product Overview
- 4 Ambient Network
- 5 Installation
- 6 Configuration
- 7 Deployment
- 8 Example Deployments
- 9 Firmware Upgrades
- 10 Troubleshooting
- 11 Appendices
User Manual
3000 SERIES 3
rd
GENERATION ACTIVE RFID
5.4.3 SmartPoint SP3000
The SP3000 does not require separate installation. It is 'always-on', meaning that when it wakes up
from its deep-sleep mode
1
and it hears a network it will become a part of the network.
Please take into account that upon arrival, the SmartPoints are likely to be in a deep sleep mode to
save energy during transport. Once you have turned on your network, it can take up to two hours
for all SPs to awake
2
.
Mounting the SP is described in the deployment section of this user manual.
1 The deep-sleep mode is the default mode of the SmartPoint. In this mode it consumes as less energy as possible. Based on the
configuration of the various drivers, it wakes up to execute a task (like sampling the temperature driver). There are no other sleep
modes.
2 Assuming that no packets are missed.
25/73 Ambient Systems B.V.