User's Manual

User Manual
3000 SERIES 3
rd
GENERATION ACTIVE RFID
Ambient Studio and your network. The Serial Port Configuration dialogue is opened by clicking the
menu entry:
Connectivity Serial Port Configure.→ →
This dialogue can be used to add, remove and rename serial aliases, as well as open and close
individual aliases. For every serial alias specific settings can be set. Ambient Studio will
automatically fill in standard settings required to open a connection to a GW3000.
If you use Ambient Studio for the first time, it will automatically create a serial alias named
'<default>', that works on COM1, and attempt to open it. Using the buttons in the Serial Aliases
section, you can respectively add, rename, remove, open and close a serial alias.
In the 'Settings' section you can select the actual system Serial Port to connect to
and indicate whether the serial port should be automatically opened upon start
up (recommended). In the example, 'COM4' has been selected.
In the 'Advanced Settings' section, you can modify parameters of the serial port. Normally, you do
not need to change these. See Illustration 14.
27/73 Ambient Systems B.V.
Illustration 14: Serial port configuration