User's Manual
Table Of Contents
- 1 Preface
- 2 Introduction
- 3 Product Overview
- 4 Ambient Network
- 5 Installation
- 6 Configuration
- 7 Deployment
- 8 Example Deployments
- 9 Firmware Upgrades
- 10 Troubleshooting
- 11 Appendices
User Manual
3000 SERIES 3
rd
GENERATION ACTIVE RFID
For your convenience, you can rename '<default>' to e.g. 'My GW3000'.
Press 'OK' to apply your changes to the Serial Port configuration.
6.1.3 Checking the connection between Ambient Studio and your GW3000
The Serial Devices tab in Ambient Studio is used to display information of the currently connected
serial devices to your system.
Press the refresh button to show up-to-date information.
Ambient Studio successfully connected to your GW3000 if:
1.Check if Device reads “Gateway GW3000 (…)”, the ID displayed matches the ID of
your GW3000 and Application ID equals GW3000, GW3120 (or any other GateWay
type).
2.The status window shows “Serial port … opened” (you may need to scroll in the
status window, before you can read the message). Check if the message displays the
alias you entered in the Serial Port settings (Section 5.1.2).
28/73 Ambient Systems B.V.
Illustration 15: Serial tab, connected Gateway