User's Manual

User Manual
3000 SERIES 3
rd
GENERATION ACTIVE RFID
6.4 Enabling built-in backup batteries
When Gateways and MicroRouters are shipped, their backup battery has been disabled. You have to
enable the backup battery to make sure that the Series 3000 network remains functional during short
power shortage.
You need to perform this action only once per Gateway or MicroRouter.
Note: The backup battery must be enabled once to keep the network functional
during short mains outages.
To enable the backup battery:
1.Select the “Drivers” tab in Ambient Studio.
2.Select a Gateway or a MicroRouter from the device list (make sure DDIP level 2 is selected)
3.Select the “Power” from the DDI tree view (Illustration 18).
4.Press to configure the power driver. The power driver configuration panel appears
(Illustration 17)
5.To download the current configuration settings press download driver button, marked as A.
in Illustration 17. Wait until “Pending” returns to 0 and the values in the view are updated.
6.Set the check mark at “[backup_enabled]” (B.) under “flags”.
7.Press in front of “Power driver flags” at C. Wait until “Pending” returns to 0. The
backup battery has now been enabled for the selected device.
Tip: In the Ambient Studio Series 3000 User Manual is described how the
configurations of multiple devices can be set at once.
Note: The panels might look different in your network, depending on your
configuration and available DDI drivers.
6.5 localization
localization is discussed in the localization white paper which can be obtained on our support
31/73 Ambient Systems B.V.