User's Manual
Table Of Contents
- 1 Preface
- 2 Introduction
- 3 Product Overview
- 4 Ambient Network
- 5 Installation
- 6 Configuration
- 7 Deployment
- 8 Example Deployments
- 9 Firmware Upgrades
- 10 Troubleshooting
- 11 Appendices
User Manual
3000 SERIES 3
rd
GENERATION ACTIVE RFID
website. Please take a look at this document for more detailed information. The text in this section
discusses only localization set-up.
6.5.1 localization deployment.
Deploying a 3000 Series localization network is similar in many aspects to deploying a regular
network for e.g. temperature monitoring or inventory management. When deploying a network with
localization functionality enabled, you should try and take into account a few more aspects than you
would normally do for a monitoring deployment. In general, deploying localization infrastructure is
done by performing the following steps:
1. Place the Gateway and MicroRouters in the localization environment.
2. Configure the locations of the Gateway and the MicroRouters.
3. Configure and enable localization parameters on the SmartPoints.
In the following subsections we cover the aforementioned steps in more detail.
32/73 Ambient Systems B.V.
Illustration 17: tree view of available drivers