User's Manual
Table Of Contents
- 1 Preface
- 2 Introduction
- 3 Product Overview
- 4 Ambient Network
- 5 Installation
- 6 Configuration
- 7 Deployment
- 8 Example Deployments
- 9 Firmware Upgrades
- 10 Troubleshooting
- 11 Appendices
User Manual
3000 SERIES 3
rd
GENERATION ACTIVE RFID
When Switching to the 'gateway' network in the maintenance tab, one should see the updated
SmartPoint with the new firmware version.
If multiple SmartPoints have to be updated/upgraded a separated tool, the mass updater, can be
used as this tool runs unattended. This tool is described in the the white paper 'using the mass
updater' which can be found on the support website or by sending an email to support@ambient-
systems.net.
9.4 Remarks
● When upgrading the firmware of the gateway and the routers, it is probably easier to upload
the firmware image to the gateway but reset it after the firmware dissemination of the
MircoRouters is completed. In this case one is sure that the firmware version of all routers
and gateway is equal during the update process.
● Contact Ambient Systems Support in order to obtain a change log of the firmware version
and a list of known issues.
● If the dissemination process fails:
○ Verify that the File System is not full. If the File System is full, delete some file and start
the DD process a second time, or upload the image to this MicroRouter using the File
upload approach.
○ Verify that the MircoRouter has at least one, but preferable multiple good links to a
number of routers.
61/73 Ambient Systems B.V.