User's Manual

Note: Do not install the batteries backwards. You can permanently damage the
thermo-hygrometer. Do not use rechargeable batteries.
Note: We recommend installing Lithium AA batteries.
Reinsert the battery door into anemometer transmitter and push to tighten it.
The wind sensor LED indicator will light for 3 seconds, and then flash once per 16 seconds
thereafter. Each time it flashes, the sensor is transmitting data.
Note: If the wind sensor does not power up after inserting the batteries, press the reset button
shown in Figure.
4.3.2 Insert batteries into the rain gauge transmitter. Rotate and detach the upside
bucket, arrow direction as show in figure 5.
Figure 5
Locate the battery boor on the rain gauge transmitter, pull out the battery
compartment,
as show in Figure 6.
Figure 6
Bubble Level