Owner Manual

Figure 4

All of the LCD segments will light up for a few seconds to verify all segments are operating properly.

3. Replace the battery door, and fold out the desk stand and place the console in the upright

position.

The console will instantly display indoor temperature and humidity as designated by the

icon. The three remote temperature and humidity sensor channels will update on the

display within a few minutes on the appropriate channel.

While in the search mode, the remote search icon will be constantly displayed.

If you have more than three remote sensors (additional channels 4-8 are supported), the

display will automatically toggle between sensors until all sensors have reported in.

Do not touch any buttons until all of the remote sensors have reported in, or the radio search

icon is no longer on, otherwise the remote sensor search mode will be terminated.

When the remote sensors have been received, the console will automatically switch to the

normal mode, and all further settings can be performed.

If the remotes do not update, please reference the troubleshooting guide in Section 8.