Owner Manual

Version 1.1 ©Copyright 2015, Ambient LLC. All Rights Reserved. Page 6
2.4.1 Display Console Layout
Figure 5
2.4.2 Sensor Operation Verification
Verify the humidity sensors match closely with the console and the sensors are in the same location
(about 5 to 10’ apart). The sensors should agree within 10% (the accuracy is ± 5%). Allow about 30
minutes for all sensors to stabilize. The humidity can be adjusted or calibrated later to match each
other a known source.
Verify the temperature sensors match closely with the console and sensor array in the same location
(about 5 to 10’ apart). The sensors should be within 2°F (the accuracy is ± 1°F). Allow about 30
minutes for all sensors to stabilize. The temperature can be adjusted or calibrated later to match each
other or a known source.
3 Remote Sensor Installation
If you mount one or more of the sensors outside, it is recommended you mount the sensor(s) on a
north facing wall, in a shaded area. Direct sunlight and radiant heat sources will result in inaccurate
temperature readings. Although the sensors are water resistant, it is best to mount in a well protected
area, such as under an eve. Use a screw or nail (not included) to affix the remote sensor to the wall, as
shown in Figure 6.