User manual

Parts List

QTY

Item

Display Console

Frame Dimensions (LxHxW): 4.50 x 5.0 x 1.00 in

LCD Dimensions (LxW): 3.75 x 3.50”

LCD Segment Height: 1.25 inches

2.2 Display Console Set Up

1. Move the remote thermometer(s) about 5 to 10’ away from the display console (if the sensor

is too close, it may not be received by the display console). If you have more than one probe

thermometer, make sure they are all powered up and transmitting on different channels.

2. Remove the battery door on the back of the display, as shown in Figure 1. Insert four AAA

(alkaline or lithium, avoid rechargeable) batteries in the back of the display console.

Figure 1

All of the LCD segments will light up for a few seconds to verify all segments are operating properly.

3. Replace the battery door, and fold out the desk stand and place the console in the upright

position.

The console will instantly display indoor temperature as designated by the icon. The

remote temperature probes will update on the display within a few minutes on the

appropriate channel.

While in the search mode, the remote search icon will be constantly displayed for each

sensor.

If you have more than two remote sensors (additional channels 3-8 are supported), the

display will automatically toggle between sensors until all sensors have reported in.

Do not touch any buttons until all of the remote sensors has reported in, or the radio search

icon is no longer visible, otherwise the remote sensor search mode will be terminated.

When the remote sensor temperature has been received, the console will automatically

switch to the normal mode, and all further settings can be performed.