User manual

Problem

Solution

Wireless remote (probe thermometer) not

reporting in to console.

There are dashes (--.-) on the display

console.

If any of the sensor communication is lost, dashes (--.-)

will be displayed on the screen. To reacquire the signal,

press and hold the CHANNEL/+ button for 3 seconds,

and the remote search icon will be constantly

displayed. Once the signal is reacquired, the remote

search icon will turn off, and the current values

will be displayed.

The maximum line of sight communication range is 300’

and 100’ under most conditions. Move the sensor

assembly closer to the display console.

If the sensor assembly is too close (less than 5’), move

the sensor assembly away from the display console.

Make sure the remote sensor LCD display is working

and the transmitter light is flashing once per 60 seconds.

Install a fresh set of batteries in the remote probe

thermometer. For cold weather environments, install

lithium batteries.

Make sure the remote sensors are not transmitting

through solid metal (acts as an RF shield), or earth

barrier (down a hill).

Move the display console around electrical noise

generating devices, such as computers, TVs and other

wireless transmitters or receivers.

Move the remote sensor to a higher location. Move the

remote sensor to a closer location.

Temperature sensor reads too high in the

day time.

Make sure the probe thermometer is mounted in a shaded

area on the north facing wall. Consider the following

radiation shield if this is not possible:

http://www.ambientweather.com/amwesrpatean.html

Indoor and Outdoor Temperature do not

agree

Allow up to one hour for the sensors to stabilize due to

signal filtering. The indoor and outdoor temperature

sensors should agree within 2 °F (the sensor accuracy is

± 1 °F).

Use the calibration feature to match the indoor and

outdoor temperature to a known source.

Display console contrast is weak

Replace console batteries with a fresh set of batteries.