User manual

(alkaline or lithium, avoid rechargeable) batteries in the back of the display console.

Figure 4

All of the LCD segments will light up for a few seconds to verify all segments are operating properly.

3. Replace the battery door, and fold out the desk stand and place the console in the upright

position.

The console will instantly display indoor temperature as designated by the icon. The

remote temperature probes will update on the display within a few minutes on the

appropriate channel.

While in the search mode, the remote search icon will be constantly displayed for each

sensor.

If you have more than two remote sensors (additional channels 3-8 are supported), the

display will automatically toggle between sensors until all sensors have reported in.

Do not touch any buttons until all of the remote sensors has reported in, or the radio search

icon is no longer visible, otherwise the remote sensor search mode will be terminated.

When the remote sensor temperature has been received, the console will automatically

switch to the normal mode, and all further settings can be performed.

If a remote does not update, please reference the troubleshooting guide in Section 7.

2.2.1 Display Console Layout

Note: The following illustration shows the full segment LCD display for description purposes

only, and will not appear like this during normal operation.