User manual

1. Remove the battery door on the back of the sensor by removing the set screw, as shown in

Figure 1 .

Figure 1

2. BEFORE inserting the batteries, locate the dip switches on the inside cover of the lid of the

transmitter.

Figure 2 displays all four switches in the OFF position (factory default setting).

Figure 2

3. Channel Number: The WS-08 supports up to eight transmitters. To set each channel number

(the default is Channel 1), change Dip Switches 1, 2 and 3, as referenced in Table 1.

4. Temperature Units of Measure: To change the transmitter display units of measure (°F

vs. °C), change Dip Switch 4, as referenced in Table 1.