User manual

6. Specifications

6.1 Wireless Specifications

• Line of sight wireless transmission (in open air): 300 feet

• Frequency: 433 MHz

• Update Rate: 48 seconds

6.2 Measurement Specifications

The following table provides specifications for the measured parameters.

Measurement Range Accuracy Resolution

Indoor Temperature 32 to 140 °F ± 2 °F 0.1 °F

Outdoor Temperature -40 to 149 °F ± 2 °F 0.1 °F

Indoor Humidity 20 to 95% ± 5% 1 %

6.3 Power Consumption

• Base station : 2 x AA 1.5V Alkaline batteries

• Remote sensor : 2 x AAA 1.5V Alkaline batteries

• Battery life: Minimum 24 months for base station

Minimum 24 months for remote thermometer sensor (use lithium batteries in cold weather

climates)

7. Troubleshooting Guide

If your question is not answered here, you can contact us as follows:

1. Email Support: support@ambientweather.com

2. Live Chat Support: www.ambientweather.com/chat.html

(M-F 8am to 4pm Arizona Time)

3. Technical Support: 480-283-1644 (M-F 8am to 4pm Arizona Time)

Problem Solution

Wireless remote (thermometer) not

reporting in to console.

There are dashes on the display console.

The maximum line of sight communication range is

300’. Move the sensor assembly closer to the display

console.

If the sensor assembly is too close (less than 10’), move

the sensor assembly away from the display console.

Cycle power on the console by removing the batteries,

waiting 5 seconds, and reinserting the batteries. The

console may have exited the search mode.

Install a fresh set of batteries in the remote thermometer.

For cold weather environments, install lithium batteries.

Make sure the remote sensors are not transmitting

through solid metal (acts as an RF shield), or earth

barrier (down a hill).