User manual

Version 1.7 ©Copyright 2012, Ambient LLC. All Rights Reserved. Page 11
Problem Solution
Move the display console around electrical noise
generating devices, such as computers, TVs and other
wireless transmitters or receivers.
Move the remote sensor to a higher location. Move the
remote sensor to a closer location.
Radio Frequency (RF) Sensors cannot transmit through
metal barriers (example, aluminum siding) or multiple,
thick walls.
Temperature sensor reads too high in the
day time.
Make sure the thermometer is mounted in a shaded area
on the north facing wall. Consider the following
radiation shield if this is not possible:
http://www.ambientweather.com/amwesrpatean.html
Indoor and Outdoor Temperature do not
agree
Allow up to 30 minutes for the sensors to stabilize due to
signal filtering. The indoor and outdoor temperature
sensors should agree within 4 °F (the sensor accuracy is
± 2 °F)
Humidity is reading 20% at low humidity
or 95% at high humidity
The humidity sensor is out of range (20 to 95%)
Display console contrast is weak Replace console batteries with a fresh set of batteries.
8. Accessories
The following software and hardware accessories are available for this weather station
at www.AmbientWeather.com
.
Accessory Image Description
Energizer AA Lithium
Battery (2-pack) - Batteries
for Long Life and Cold
Climates
AA lithium batteries for cold weather
climates.
SRS100LX Temperature
and Humidity Solar
Radiation Shield
Solar Radiation Shield improves temperature
accuracy for hot weather climates. Remove
the rain guard and install over thermometer.
Ambient Weather WH3C
WH-3C Wireless
Thermometer
Add two additional remote wireless
thermometers for a total of three remote
sensors.
Ambient Weather
WS-1280-C Wireless
Weather Forecaster with
Indoor
Temperature, Humidity and
Outdoor Temperature
(console only)
Add multiple consoles throughout your house
or business. Each console can read up to three
remote sensors.