User manual

2.4.2 Display Console Layout

Note: The following illustration shows the full segments of the LCD for description purposes

only and will not appear like this during normal operation.

Figure 2

1. Weather tendency arrow

2. Weather forecast icon

3. Time alarm icon

4. WWVB tower icon for time reception

(will briefly flash when received)

5. Time / Date

6. MIN/MAX icon

7. Receiver low battery indicator

8. Indoor temperature display

9. Indoor Humidity display

10. MIN/MAX icon

11. Transmitter low battery indicator

12. Outdoor temperature display

13. Number showing sensor unit

14. Outdoor receiption signal

2.5 Sensor Operation Verification

Verify the indoor and outdoor temperature match closely with the console and sensor array in the same

location (about 10’ apart). The sensors should be within 4°F (the accuracy is ± 2°F). Allow about 30

minutes for both sensors to stabilize.

3. Remote Sensor Installation

It is recommended you mount the remote sensor on a north facing wall, in a shaded area. Direct

sunlight and radiant heat sources will result in inaccurate temperature readings. Although the sensor is

water resistant, it is best to mount in a well protected area, such as an eve.

Use 3 screws to affix the mounting bracket to the wall. Connect the remote sensor to the wall

bracket with a precision screwdriver.