User manual

Figure 3

4. Console Operation

Note: After 30 seconds of inactivity, the display will automatically revert to the normal display

mode (automatic time out).

Note: The SET and MODE functions use the same button and are used interchangeably. The

MIN/MAX/- functions use the same button and are used interchangeably. The CH/+ functions use

the same button and are used interchangeably.

Note: There are two modes of operation (1) normal mode, and (2) set mode, where settings are

programmed.

4.1 Time Modes

Press the MODE button until the arrow (Î) is pointing at the date and time field.

4.1.1 Set Time, Date, Units and Storm Threshold

Press the SET key for 3 seconds to enter the SET Mode and the DST (daylight savings time) will flash.

Press the CH/+ key to switch between ON and OFF. Press the SET key to confirm the selection.

The time zone will flash. Press the CH/+ key to advance the time zone (or MIN/MAX/- to decrement

the time zone). Reference the table below to determine your time zone setting. Press the SET key to

confirm the selection.

The 12H will flash. Press the CH/+ key to switch between the 24 hour (24H) and 12 hour (12H) time

display mode. Press the SET key to confirm the selection.

The hour will begin flashing. Press the CH/+ key to advance the hour (or MIN/MAX/- to decrement

the hour). Note that the PM icon will be displayed for afternoon hours. Press and hold the CH/+ key