User manual

Hours from

GMT

Time Zone Cities

10 GST: Guam Standard Sydney

11 --- Magadan

12 IDLE: International Date Line East

NZST: New Zealand Standard

Wellington, New Zealand

4.1.2 Set Alarm Time

Press the MODE button until the arrow (Î) is pointing at the date and time field. Press the CH/+

until the alarm time is displayed, as shown in the figure below.

Press the SET key for 3 seconds to enter the SET Mode and the alarm hour will flash. Press the CH/+

key to advance the alarm hour (or MIN/MAX/- to decrement the alarm hour). Note that the PM icon

will be displayed for afternoon hours. Press and hold the CH/+ key to advance rapidly. Press the

SET key to confirm the alarm hour selection.

The alarm minute will begin flashing. Press the CH/+ key to advance the alarm minute. Press and

hold the CH/+ key to advance rapidly. Press the SET key to confirm the alarm minute selection.

The time alarm will now be active and alarm symbol

will be displayed.

4.1.3 Turning On and Off the Time Alarm

While in Normal Mode, select the MIN/MAX/- key to turn on and off the alarm.

4.1.4 Displaying the Date and Alarm Time

While in Normal Mode, select the CH/+ key to view the date. Select the CH/+ key again to view the

alarm time.

4.2 Indoor Temperature and Humidity Mode

Press the MODE button until the arrow (Î) is pointing at the indoor temperature and humidity field.

4.2.1 Displaying and Resetting the Indoor Temperature and Humidity

Min and Max Values

Press the MIN/MAX key to display the maximum indoor temperature. Press and hold the MIN/MAX

key for three seconds to reset the maximum indoor temperature to the current value.

Press the MIN/MAX key again to display the minimum indoor temperature. Press and hold the

MIN/MAX key for three seconds to reset the minimum indoor temperature to the current value.

Press the MIN/MAX key again to display the maximum indoor humidity. Press and hold the

MIN/MAX key for three seconds to reset the maximum indoor humidity to the current value.