User manual

1. Introduction

Thank you for your purchase of the Ambient Weather WS-0101 Wireless Weather Station with time,

indoor temperature and outdoor temperature and outdoor humidity with calibration. The following

user guide provides step by step instructions for installation, operation and troubleshooting. To

download the latest manual and additional troubleshooting tips, please visit:

http://ambientweather.wikispaces.com/ws0101

2. Getting Started

The WS-0101 weather station consists of a display console (receiver), and a thermo-hygrometer

(remote transmitter).

2.1 Parts List

QTY Item

1 Display Console

Frame Dimensions (LxWxH): 4.5 x 2.5 x 1.0 in

LCD Dimensions (LxW): 2.25 x 1.75”

1 Thermo-hygrometer transmitter (WH2B) with mounting bracket

Dimensions (LxWxH): 3.5” x 2.5” x 0.9”

2.2 Recommend Tools

• Philips screwdriver (precision)

• Drill for mounting bracket

2.3 Thermo-Hygrometer Sensor Set Up

Note: To avoid permanent damage, please take note of the battery polarity before inserting the

batteries.

Remove the battery door on the back of the sensor with a Philips screwdriver (there is only one screw,

at the bottom of the unit). Insert two AAA batteries as shown in Figure 1 (we recommend lithium

batteries for cold weather climates, but alkaline batteries are sufficient for most climates).

Replace the battery door and set screw. Note that the temperature and humidity will be displayed on

the LCD display. Looking at the back of the unit from left to right, the polarity is (-) (+) for the top

battery and (+) (-) for the bottom battery.