User manual

Figure 3

4. Console Operation

Note: After 30 seconds of inactivity, the display will automatically revert to the normal display

mode (automatic time out).

4.1 Set Mode

Note: The SET and MIN/MAX functions use the same button and are used interchangeably. The

RESET and CH/+ functions use the same button and are used interchangeably.

Press and hold the SET for two seconds to enter the set mode.

1. Hour Format. The 12H will begin flashing. Press the CH/+ key to toggle between the 24

hour (24H) and 12 hour (12H) time display mode. Press the SET key to confirm 12/24 hour

format selection.

2. Temperature Units of Measure. The °F icon will begin flashing. Press the CH/+ key to

toggle between the °F and °C units of measure. Press the SET key to confirm the units of

measure selection.

3. Hour of Day. The hour of day will begin flashing. Press the CH/+ key to advance the hour.

Note that the PM icon will be displayed for afternoon hours. Press and hold the CH/+ key

to advance rapidly. Press the SET key to confirm the hour selection.

4. Minute of Hour. The minute will begin flashing. Press the CH/+ key to advance the minute.

Press and hold the CH/+ key to advance rapidly. Press the SET key to confirm the minute

selection.

5. Humidity Calibration. The remote humidity will begin flashing. Press the CH/+ key to

increase the humidity reading in 1% increments (when 100% is reached, it rolls over to 0%).

To reset the outdoor humidity to the measured value, press and hold the CH/+ key for three

seconds.

Press the SET key to confirm the calibrated humidity selection. If you have more than one

remote thermo-hygrometer, channel 2 humidity will begin flashing. Repeat this step of

optional channel 2 and channel 3 sensors.

Press the SET key again to exit the SET mode.